IKEA TRIXIG Original Instructions Manual page 11

Note: The battery that is supplied with the screwdriver/drill has been charged for test
purposes only and must be fully recharged before first time use.
TRIXIG screwdriver/drill and TRIXIG battery pack have been designed to be used together.
NEVER use this battery pack to power cordless tools from other manufacturers.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the machine is switched off by means of a
protective circuit: The inserted tool no longer rotates.
WARNING Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
WARNING! Recharge the battery on a non-flammable surface. Do not recharge
the battery for more than eight hours.
INSTRUCTIONS FOR USE
Using the tool
Note: Sparks may be visible through the slots in the motor housing during operation. The
sparks are a normal reaction of the motor when in use and are created by the components
inside the motor moving against each other. The function of the power tool is not affected
by this. We do however recommend not to use the power tool near any flammable liquids,
gases or dust, which the sparks may ignite.
Keyless chuck
Your drill has a keyless chuck so that you can simply tighten or release screwdriver/drill
bits. Hold the front sleeve and push on the speed control/trigger to open/close the chuck.
Mounting bits and drills
Before any work on the machine (e.g. maintenance, tool change, etc.) as well as during
transport and storage, set rotational direction switch to the centre position. Unintentional
actuation of the trigger can lead to injuries.
Rotate the front sleeve to adjust the chuck until the opening is slightly larger than the
shaft of the screwdriver/drill bit that you wish to use. Insert the screwdriver/drill bit into
the chuck. Tighten the chuck against the screwdriver/drill as described above (Keyless
chuck).
Regulating the shaft speed
It is possible to regulate both shaft speeds from zero to maximum by altering the pressure
applied to the trigger. This enables you to choose the optimum speed for the task you are
working on.
Reversing the direction of rotation
You can reverse the direction of rotation by using the rotational direction switch (4).
To lock the trigger, set the selector to the mid position between the right and left options.
Adjusting the tightening moment
Turn the torque regulator (2. to the desired position. Settings 1-19 are used for tightening/
loosening screws (the higher the value, the greater the tightening moment). Select the
drill symbol before using the tool for drilling.
11