Speaker Connections - Sonoro Maestro SO-1010 Operating Manual

3.5

Speaker connections

NOTICE!
Risk of damage!
• Disconnect the power plug from the power outlet before connecting the
speakers.
• Never touch the speaker terminals while the power cord is connected. Doing
so could result in electric shock.
• Use speakers with an impedance of 4 – 16 Ω.
Speakers can be connected to MAESTRO as show below.
Connecting the speaker cables
1. Remove approximately 10mm of insulation from the end of each speaker
cable. Then, twist the bare wires of the cable firmly together.
2. Unscrew the knob.
3. Insert one bare wire into the hole in the side of each terminal.
4. Tighten the knob to secure the wire.
+ (Red)
- (Black)
84
Speakers
(L) (R)
© sonoro audio GmbH 2023