Table of Contents
Advertisement
1. Insert the bolt rails (1) on the right and left in the upper wood slat (2). Insert the bolt rails (1)
right and left in the lower wood slat (2).
2. Slide the entire bolt rails (1) + wooden slats (2) in the relevant sliding rail (3) from the head
and foot panel. Grasp the upper wooden slat and pull upwards until the wooden side rails lock
in position.
3. Insert the bolts (4) and tighten them.
4. Repeat these steps for the other side.
3.2.6
Metal side rails (not for Club
1. Place the hooks (1)
over the frame tube (2).
2. Tighten the star knob
(3). Make sure that
both sides have been
tightened securely.
3. Repeat for the other
side rail.
3.2.7
Split side rails (not for Club
Mind the difference between head-end and foot-end rails
(head-end rails are shorter than foot-end rails).
1. Take one of the split side rails.
2. Place the split side rail attachments (1) over the mattress
frame support (2).
3. Firmly tighten the two screws (3) on the bottom of each
attachment.
4. Repeat for all other split side rails.
5. Make sure that all side rails are firmly attached into place.
3.2.8 Transformer connections
CAUTION
Do not place any objects on the connection and the cable, and protect them against mechanical
loads.
1. Connection requires a 220V/230V, 50Hz power socket conform to VDE specifications.
2. The diagram for the transformer connections is given in the figure below. To insert the
cables, open the top lid of the transformer. Otherwise the cables will not be secured into
place.
)
UL
1
3
)
UL
Risk of injury
Installation manual
9
Club
2023-05
Assembly
1
2
3
2
1
3
EN
NL
Advertisement
Table of Contents
