Table of Contents
Advertisement
TRUE
tdc
LOCATING
A. Remove packing material from cabinet.
B.
Remove skid by unscrewing all base brackets shown in photo 1
and illustration 1.
C. Carefully remove unit from shipping skid and place the skid to
the side.
D. Applicance tested according to the climate classes 5 and 7 for
temperature and relative humidity.
1
Illustration 1.
5
Removing skid from bottom
of cabinet.
LEVELING
A. Set unit in its final location. Be sure there is adequate ventilation
in your room. Under extreme heat conditions, (100°F+,
38°C+), you may want to install an exhaust fan.
WARNING: WARRANTY IS VOID IF VENTILATION IS
INSUFFICIENT.
B.
Proper leveling of your TRUE cooler is critical to operating
success (for non-mobile models). Effective condensate removal
and door operation will be effected by leveling.
C. The cooler should be leveled front to back and side to side with
a level.
D. Ensure that the drain hose or hoses are positioned in the pan.
E.
Free plug and cord from inside the lower rear of the cooler
(do not plug in).
F.
The unit should be placed close enough to the electrical supply
so that extension cords are never used.
NOTE: IF THE CABINET HAS A CENTER LEVELING
SCREW, CASTOR, OR LEG, MAKE SURE IT
IS ADJUSTED PROPERLY SO IT MAKES FULL
CONTACT WITH THE FLOOR AFTER THE CABINET
HAS BEEN LEVELED.
WARNING: CABINET WARRANTIES ARE VOID
IF OEM POWER CORD IS TAMPERED WITH. TRUE
WILL NOT WARRANTY ANY UNITS THAT ARE
CONNECTED TO AN EXTENSION CORD.
.
.
www
truemfg
com
Advertisement
Table of Contents
