Table of Contents
Advertisement
Installation (cont.)
Cabinet Location
1. Do not place THAC unit in an area that will obstruct air flow
through the front louver grill.
2. Ensure that the drain hose or hoses are positioned in the pan.
3. Free the plug and cord from inside the lower rear of the cooler
(DO NOT plug in).
4. Place the unit close enough to the electrical supply so that the
extension cords are never used.
Installing Standard Leveling Legs
Leveling legs are provided to assist with the leveling of the cabinet.
1. Access the bottom of the cabinet and locate the
leveling legs. See fig. 1.
2. The leveling legs may be threaded in or out to
achieve a level and supported cabinet.
See figs. 2 and 3.
Installing Castors
Optional castors will provide cabinet mobility.
NOTE: If the cabinet has a center leveling screw or castor, make
sure it is adjusted properly so it makes full contact with the floor
after the cabinet has been leveled.
Tools Required
• Phillips Screwdriver
• Adjustable Wrench
• Castor Wrench (optional)
Castors
1. Loosen the castor bolt enough to slide the provided castor
shims between the castor bearing and the bottom rail of
the cabinet. See fig. 4.
2. Install the desired number of shims. If more than one shim is
used, turn the slots at a 90˚ angle to each other, so the slots do
not align. See figs. 5 and 6.
3. Tighten and secure the shims and castors with the optional
castor wrench. Lower the cabinet and verify that it is level. If
the cabinet is not level, repeat the process until the cabinet is
level and supported.
– Units may pose a tipping hazard
WARNING
while uncrating, during installation, or when
moving the unit.
TEC_TM_087 REV. A
THAC | HORIZONTAL AIR CURTAIN
Fig. 1. Remove the screws from the front louver grill..
Fig. 2. Turn the leveling legs clockwise to lower the unit.
Fig. 3. Turn the leveling legs counterclockwise to raise the unit.
Fig. 4. Loosen castor bolt.
Fig. 6. Position multiple shims at
90˚ angles.
09/25/2020
truemfg.com
Fig. 5. Install shim(s).
Castor Stem
Lower Rail Assembly
Rail End
Snug Fit Here
Bearing Race
Leveling Shim
Castor
Page 7 of 18
Advertisement
Table of Contents
