Table of Contents
Advertisement
4.
INSTALLATION STEPS
Before starting the installation, check the availability of all the necessary components and tools:
- Drill
- Screwdriver
- Hydraulic installation components
- Electric installation components
Once it has been checked that it is available all the necessary components and tools, the
installer should follow the next steps:
1. Placing the ECOHEAT
2. Hydraulic installation
3. Air connections
4. Electric installation
5. Commissioning
5.
PLACING ECOHEAT
The place where the system will be installed should allow an easy access to make maintenance
work or inspection.
Air outlet of ECOHEAT is around 5-10 degrees below inlet temperature, so in case that the
exhaust air would not be ducted, the room temperature will be considerably reduced.
Beside these factors, it is important to consider the following indications regards the installation
site:
- The system has been designed and manufactured for it indoors utilization. Install the
system in a dry, frost-free room at a minimum temperature of 5 ºC. The surface on which
it is to be installed must be able to support the total load of the system.
- As the equipment may cause vibrations or noise, it is recommended to install away from
resting places.
- Installer must install the supplied Silent blocks to avoid the transmission of vibration.
5
INSTALLATION AND USER MANUAL
ECOHEAT
V2REV2EN0822
Advertisement
Table of Contents
