Table of Contents
Advertisement
10. WARRANTY CONDITIONS
Component
Stainless steel tank 2205
Electrical, electronic and mechanical removable components
The warranty exclusively covers productions faults of the product, excluding any liability for any material damage or injury that results directly or
indirectly from the use of this product.
The warranty takes effect from the moment that the system is installed, perfectly justified via the commissioning file correctly completed and sent to
the factory within 2 months, or in absence of this justification, the date that shall be take into consideration is the invoice date.
The installer or distributor of the product is the solely responsible for compliance with the installation rules given by the manufacturer.
Failures or incidences due to the following reasons are excluded from the warranty:
- Handling or repair the product by unauthorised personnel.
- Damage caused by impact or fall during handling the product after it leaves the factory.
- To exceed the maximum accumulation temperature. The maximum accumulation temperature in all buffer tanks, unless otherwise indicated
by Climer Technology, S.L.L., is 85ºC. The most restrictive operating temperature range of those indicated in this document, data sheet,
equipment manual and identification label will always prevail, contrary indication expressed by Climer Technology, S.L.L.
- Damage to the tank, result of malfunction from the overpressure limiting valve. Maximum 3 bars in the secondary, 9 bars in the primary and 9
bars in consumption and failing that indicated in the identification label of the equipment, applying as maximum pressure of each circuit the
most restrictive.
- Location of the product at any place subject to high temperature, humidity, inclemency, frost, aggressive environment...
- Fault caused by an erroneous installation, which makes the product work out of its design conditions.
- Faults caused by not having installed the supplied security group or incorrect installation thereof.
- Overvoltage power supply (grid, beam...)
- Faulty electrical connection, insufficient wire section, non-compliance with electrical schemes...
- Use water within any of the following criteria:
Calcium carbonate (CaCO
o
> 50 mg/L free carbon dioxide
o
Alkalinity > 150 mg/L
o
Water pH less than 6 and greater than 9, measured at 20 ºC
o
> 250 mg/L total of chlorine derivatives chlorides
o
In general, any condition that exceeds the maximum allowed values
- Fault due to galvanic corrosion result from direct connection of copper pipes without electrolytic sleeve
- Installation of the product in a manner not in accordance with the operating instructions
- Damages result from problems that could not be detectable due to the location of the system (hardly accessible place) and that could have
been avoided by a prompt reparation of the product.
- Switch on the heating system without filling the tank (dry heating).
- Any modification of the product without prior agreement with the manufacturer or use spare parts non-authorized or non-supplied by the
manufacturer.
Based on these considerations, the warranty comprises in replacing the faulty component to the Installer or Distributor. Transport cost, labour or any
compensation are excluded from the warranty.
The fault in single components never comprises the replacing of the product. The installer or distributor is responsible of the changing or reparation
of the defective part.
The warranty of the replaced spare part has the same vigour as the product, shall not entail hence the warranty period to be extended or a new
warranty period to commence.
19
MANUFACTURER WARRANTY CONDITIONS
) content > 200 mg/L
3
INSTALLATION AND USER MANUAL
Warranty period
5 years
2 years
ECOHEAT
V2REV2EN0822
Advertisement
Table of Contents
