Table of Contents
Advertisement
Installation
Removing the transport bolts
CAUTION
DAMAGE TO THE APPLIANCE OR INJURY POSSIBLE
⚫ The washer is secured for transport with
transport bolts. Transport bolts that are not
removed can damage the drum during operation
of the washer, the washer will vibrate, and it will
be much noisier during spin cycles if the
transport bolts are not removed before use. Be
sure to remove all 4 transport bolts completely
before first use. Keep the transport bolts. If a
pedestal was purchased with the washer, it must
be installed first, prior to removing the transport
bolts. Please consult the pedestal installation
instructions.
⚫ In order to prevent transport damage during later
transport, be sure to re-install the bolts before
transport.
1. Undo the four transport bolts A by the wrench
(supplied) and remove them.
2. Remove the four spacers B. They will fall to the
floor when you tip the machine.
3. Insert the four cover caps C which will find in the
plastic bag containing the accessories.
Keep all the parts in safe place: you will need them
again if the washer needs to be moved to another
location.
NOTE
• Transport the washer for the prevention of
breakage as below:
- The transport bolts are reinstalled.
- The power cord is secured to the back of the
washer.
Choosing the right location
Locations the appliance is not to be
●
installed
- In a damp place or where the washer may be
exposed to rain, etc.(As this could cause electric
shock or fire)
- Locations that are uneven, or unstable (As this
could cause vibration and noise).
- In direct sunlight (As this could cause malfunction
or deformation)
- Within, or on top of, unstable surfaces, including
but not limited to benchtops, timber shelving, or
cabinets.
CANTION: Do not install where temperatures
may reach freezing
Set-in Installation
●
- Install the washer with easy access to the power
plug and socket.
- Install the washer where there is enough space
around it.
(a) 3cm or more
above
(b) 5cm or more
behind
(c) 2cm or more on
the left side
(d) 2cm or more on
the right side
(e) 64cm or more
CAUTION: Do not let metallic portions of the
washer come into contact with metal sinks or
other appliances.
8
Advertisement
Table of Contents
