Table of Contents
Advertisement
Safety instruction
INSTALLATION
The washer must be handled and installed by two
or more persons – risk of injury. Use protective
gloves to unpack and install – risk of cuts.
The washer must be installed and operated in a
room with the drain.
Installation, including water supply (if any) and
electrical connections and repairs must be carried
out by a qualified technician. Keep children away
from the installation site. After unpacking the
washer, make sure that it has not been damaged
during transport. In the event of problems, contact
the dealer or your nearest After-Sales Service. Once
installed, packaging waste (plastic, Styrofoam parts
etc.) must be stored out of reach of children – risk
of suffocation. The washer must be disconnected
from the power supply before any installation
operation – risk of electric shock. During installation,
make sure the washer does not damage the power
cable – risk of fire or electric shock. Only activate
t h e w a s h e r w h e n t h e i n s t a l l a t i o n h a s
been completed.
Do not install the washer where it may be exposed
to extreme conditions, such as: poor ventilation,
temperatures below 5℃ or above 35℃.
Do not expose the washer in the place with
causticity or explosibility gas.(e.g. dust, steam and
gas, etc.)
Do not install the washer in a bathroom or a room
very wet.
The washer should not be installed in an outdoor
environment, not even where the area is sheltered,
because it may be very dangerous to leave it
exposed to damp, rain and thunderstorms.
When installing the washer make sure that the
four feet are stable and resting on the floor,
adjusting them as required, and check that the
appliance is perfectly to level using a spirit level.
The washer must not be installed behind a
lockable door, a sliding door or a door with a hinge
on the opposite side to that of the washer, in such
way that a full opening of the washer door is
restricted.
After installation of the washer, wait a few hours
before starting it so that acclimates to the
environmental conditions of the room.
Make sure that the ventilation openings in the
base of the washer (if available on your model) are
not obstructed by a carpet or other material.
When moving, do not lift the washer by the knobs
or detergent drawer, without lifting it by the
worktop or top lid; during transport, never rest the
door on the trolley.
The washer is fitted with transport bolts to
prevent any possible damage to the interior during
transport. Before using the machine, it is imperative
that the transport bolts are removed. After their
removal, cover the openings with the 4 enclosed
plastic caps.
Connect the water inlet hose(s) to the water
supply in accordance with the regulations of your
local water company.
Use only the new water inlet hose(s) supplied with
the washer to connect the washer to water supply.
The old water inlet hose(s) should not be reused.
The supply water pressure must be in the
0.03—1.0 MPa range.
3
Advertisement
Table of Contents
