Table of Contents
Advertisement
How to use the appliance
Before loading your first load of
laundry
Your new washer was tested before leaving the
factory. This process involves running various wash
cycles. As a result, a small amount of water may
remain in the tub and drainage system. Run a Drum
Clean
cycle with no laundry to clean the system
before your first load of laundry.
First add 1 to 2 tablespoons of detergent to the
chamber I. Then run the Drum Clean
Wait for the cycle to finish.
Daily use
Preparing the laundry
EMPTY POCKETS
· Coins, paper clips, etc. could damage the load
and the washing machine components.
· Tissues will break down during the wash cycle
and the fragments will have to be subsequently
removed by hand.
CLOSE ALL ZIPPERS, BUTTONS, AND HOOKS. TIE
ALL RIBBONS OR BELTS
· Insert the smaller garments (e.g. nylon hosiery,
belts, etc.) and garments with hooks (e.g.
braziers) into a fabric bag or a pillowcase with
zipper. Remove any rings from curtains, or else
place the curtains inside a fabric bag together
with the rings.
FABRIC TYPE/SYMBOL ON THE WASH LABEL
· Cottons, mixed fibres, easy care/synthetics, wool,
hand wash items.
· Color
Separate colored and white items. Wash new
colored articles separate.
· Size
Wash items of different sizes in the same wash
load, to improve washing efficiency and
distribution of the articles in the drum.
· Delicates
Wash delicate items separately; they require
gentle treatment.
How to use the washer
1. Load laundry
Open the door and load the laundry. Load the
articles one at a time loosely into the drum,
without overfilling. Observe the load sizes given
in the "Table of wash cycle", Overloading the
machine will result in unsatisfactory washing
results and creased laundry.
2. Close door
cycle.
Make sure that no laundry gets stuck between
door glass and rubber seal. Close the door so that
you can hear it click shut.
3. Open water tap
Make sure that the washing machine is
connected to the water mains. Open the water
tap.
4. Set the desired program
Select the required program with WASH CYCLE
SELECTOR knob. The duration of the wash cycle is
shown on the display. The washing machine
automatically displays the default temperature
and spin speed settings possible for the selected
program. Adjust the temperature and/or spin
speed setting if needed with the relative buttons.
· Change temperature, if needed
Press the TEMP. button to progressively lower
the temperature setting until cold wash has been
set (all temperature value indicator light go out
on the display). Pressing the button again sets
the highest possible setting.
· Change spin speed, if needed
Press the SPEED button to progressively decrease
the spinning speed until the spin cycle is turned
off (all spinning speed value indicator light go out
on the display). Pressing the button again sets
the highest possible setting.
· Select options, if needed
Press the button to select the option; the
respective option indicator on the display
illuminates.
Press the button again to cancel the option; the
respective option indicator extinguishes.
21
Advertisement
Table of Contents
