Table of Contents
Advertisement
Safety instruction
ELECTRICAL WARNING
It must be possible to disconnect the washer from
the power supply by unplugging it if plug is
accessible, or by a multi-pole switch installed
upstream of the socket in accordance with the
wiring rules and the washer must be earthed in
conformity with national electrical safety standards.
When the washer is installed, the mains
socket must be within easy reach.
When heating, the maximum current of the
washer is 10A, so please make sure that the power
supply system (voltage, current and the cable) is
applicable to the load of the applied appliance.
In order to ensure your safety, you must plug the
cable into a socket which connected to earth. And
please check your socket to make sure that it is
connected with reliable earth correctly.
Do not use extension leads, multiple sockets or
adapters.
The electrical components must not be accessible
to the user after installation.
Do not operate this washer when you are wet or
barefoot.
Do not operate this washer if it has a damaged
power cable or plug, if it is not working properly, or
if it has been damaged or dropped.
If the supply cord is damaged, it must be replaced
with an identical one by the manufacturer, its
service agent or similarly qualified persons in order
to avoid a hazard – risk of electric shock.
Disconnect the power cord by grasping the plug,
not the cord.
The washer should not be installed in an outdoor
environment, not even where the area is sheltered,
because it may be very dangerous to leave it
exposed to damp, rain and thunderstorms.
CLEANING AND MAINTENANCE
WARNING! Ensure that the washer is switched off
and disconnected from the power supply and turn
off
the
water
maintenance operation; never use steam cleaning
equipment – risk of electric shock.
Use caution when draining hot water from the
drum such as during pump maintenance or when
using emergency door open procedure.
SERVICE
Do not repair or replace any part of the washer
unless specifically stated in the user manual. Use
only
authorized After-sales
non-professional repair may lead to dangerous
incident resulting in live or health threatening
and/or significant property damage.
In the event of fault and/or malfunction, turn off
the washer, close the water tap and do not tamper
with the machine. Immediately contact the
Customer Service Centre and only use original spare
parts. Failure to observe these instructions may
jeopardise appliance safety.
Certain internal parts are intentionally not
grounded and may present a risk of electric shock
only during servicing. Service personnel – Do not
contact the following parts while the appliance is
energized: Control board, heat sink, motor, inlet
valve and pump.
Always unplug the washer from the power supply
before attempting any service. Disconnect the
power cord by grasping the plug, not the cord.
Before the washer is removed from service or
discarded, remove the door to prevent children
from playing or hiding inside. Also remove the
power cord/plug.
WARNING! The company denies all liability if and
when these norms are not respected.
4
tap
before
performing
Service. Self or
any
Advertisement
Table of Contents
