Checking The Water Inlet Hose; Cleaning The Detergent Dispenser; Cleaning The Mesh Filter In The Water Supply Hose - New World NWWM814W User Manual

Care and maintenance

Checking the water inlet hose

Check the water inlet hose at least once a year. If
there are any cracks, it should be replaced
immediately, during the wash cycle, water pressure
is very strong and a cracked water inlet hose could
easily spilt open.
 Never use second-hand water inlet hose.

Cleaning the detergent dispenser

If there is a buildup of residual detergent or
additives, or if the softener compartment is not
rinsed out well enough, it may be helpful to clean
the dispenser.
1. Open the detergent dispenser tray fully. Press
down on the drawer catch (1) and pull the the
tray (2) from the washer housing.
2. Remove the liquid detergent cover (3) by
grasping it and pulling it upwards from the
detergent dispenser tray.
3. Clean the liquid detergent cover and the
detergent dispenser tray by holding it under
runing water. Lightly wipe away any remaining
detergent residue.
4. Attach the liquid detergent cover and slide the
detergent dispenser tray back in place and close
the tray securely.
Tip: Do not operate the washer without the
detergent dispenser tray in place. Always keep the
tray completely closed.
Cleaning the mesh filter in the water
supply hose
1. Close water tap and unscrew the water inlet
hose.
2. Clean the mesh filter at the hose's end carefully
with a fine brush.
3. Now unscrew the inlet hose on the back of the
washer by hand. Pull out the mesh filter from the
valve on the back of the washer with pliers and
carefully clean it.
4. Insert the mesh filter again. Connect the inlet
hose to the water tap and washer again. Do not
use a tool to connect the inlet hose. Open the
water tap and check that all connections are
tight.
25