New World NWWM814W User Manual page 12

Installation
 Before connecting the drain hose ensure that
any blanks or removable ends have been taken
off the spigot.
■ Wash Basin
Make sure that:
· There is no stopper in the sink drain.
· The end of the drain hose does touch the
discharge water.
· The sink drain is free flowing and not partially
clogged.
Attach the drain hose securely to the wash basin.
 Do not twist, pull out or bend the drain hose.
 We advise against the use of hose extensions;
in case of absolute need, the extension must have
the same diameter as the original hose and must
not exceed 150cms in length. Ensure that if the
drain hose is pushed into a standpipe, that the
end does not go down more than 15cms (6 inches).
If the hose is pushed down too far, this may cause
the washer to self-syphon ie. continuously empty
as it is filling.
Electric connection
Before plugging the washer into the mains socket,
make sure that:
· The socket is earthed and in compliance with the
applicable law.
· The socket is able to sustain the appliance's
maximum power load indicated on the Technical
Date Plate fixed on the machine.
· The supply voltage is included within the values
indicated on the Technical Date Plate fixed on the
washer.
· When heating, the maximum current of the
washer is 10A, so please make sure that the
power supply system (voltage, current and the
cable) is applicable to the load of the applied
appliance.
· The socket is compatible with the washer's plug.
If this is not the case, replace the socket or the
plug by a qualified electrician.
 WARNING----THIS APPLIANCE MUST BE EARTHED.
THE FOLLOWING
CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Replace the supply cable:
If the supply cord is damaged, it must be replaced
with an identical one by the manufacturer, its
service agent or similarly qualified persons in order
to avoid a hazard – risk of electric shock.
Disposing of the plug:
Ensure that before disposing of the plug itself, you
make the pins unusable so that it cannot be
accidentally inserted into a socket.
Disposing of the appliance:
When disposing of the washer please remove the
plug by cutting the mains cable as close as possible
to the plug body and dispose of the plug as
described above.
 The washer is not intended to be operated by
means of an external switching device, Such as a
timer, or separate remote controlled system.
 When the washer is installed, the mains socket
must be within easy reach.
 Do not use extension cables, multiple sockets or
adapters.
 To remove the plug from the socket, grasp the
plug firmly and pull it out. Do not pull at the cable.
11
OPERATIONS SHOULD BE