Table of Contents
Advertisement
Installation
Connection the electricity and water
supplies
Connecting the water inlet hose
1. Connect one end of the water inlet hose to a
cold water tap and tighten by hand (see figure).
Before performing the connection, allow the
water to run freely until it is perfectly clear.
2. Connect the other end of the water inlet hose
to the water inlet valve on the rear of the appliance
and tighten by hand.
3. Turn on the tap slowly and make sure there are
no leaks.
Do not twist, squash, modify or cut the hose.
Tighten the end of the hose firmly by hand.
The supply water pressure must be in the
0.03—1.0MPa range. If the water pressure exceeds
this value, please fit a pressure reducing valve.
If the hose is not long enough, contact a
specialized shop or an authorized technician.
Never use second-hand water inlet hose.
Use the new water inlet hose supplied with the
washer.
Connecting the drain hose
Height of drain point
Height difference between the floor and drainage
point: min. 60cm(24 in.) and max. 100cm(39 in.).
Types of drainage hookups
■ Standpipe
Attach the drain hose to the elbow (no supplied,
available from our Customer Service Department).
Position the elbow on the drain hose 4" from end
of the hose as shown. Insert this section of the drain
hose into the drain pipe. Secure the elbow and
hose with a nylon tie strap or the equivalent to
keep the hose from coming out of the drain pipe
during use.
■ Sink siphon
Secure the drain hose to the sink siphon using a
Ǿ0.9-1.6 in.(20-44mm) hose clip (available from
a hardware store).
10
Advertisement
Table of Contents
