ForceDoor FS 1000 Installation Instructions And User Manual page 31

The door is fully open, automatically
close after some time
LED lights flash 4 times
When the door stops, the caution light is
always on
LED lights do not work
Door is automatically reversed to the
upper limit before the door closed
completely
Door automatically stops while opening
The remote control cannot be used or
the operation distance is short
Cannot code in the new remotes
Digital display
Standby, Digital display
The opener is working while the door is
not moving
The battery do not supply power
Other abnormal issues
Digital display
Automatic closing function is turned on
The power board is broken
1. The LED wire is not plugged
2. The LED is broken
3. The circuit board is broken
In operation with automatic reverse function
The door is not installed correctly
There is some block on its moving
In operation with automatic protect function
when obstruction is detected
The door is not installed correctly
There is some block on its moving
1. Flat battery
2. Antenna is loosed or not well extended
3. Interference around nearby
New remote control is not compatible with
opener
Stored remote code is full
Door in door function effects
Motor shaft sleeve worn
1. Flat battery
2. The battery wire is plugged inversely
3. The battery wire is broken
External devices is not compatible with the
opener
The Garage door system needs
maintenance
Set the automatic closing time, or turn off the automatic
closing function.
( Refer the instruction manual)
Replace the power board
1. Check the LED wire
2. Replace the LED
3. Replace the circuit board
1.Check the block position of the door and re-set the limit
traveling
2. Increased force number for automatic reverse
1.Check the block position of the door and re-set the limit
traveling
2. Increased force number for automatic reverse
1. Replace new battery
2. Extended the antenna on the opener
3. Get rid of interference
Choose our remote control only
Delete all stored codes
(Refer the instruction manual)
Check the door in door switch
Replace the motor shaft sleeve
1. Charge the battery
2. Open the cover, check "+" "-" of the battery
3. Replace the battery wire
Remove all the external devices. If the abnormal issues still
exist, replace the circuit board
The garage door and motor need total maintenance
27
Version： TH ( D / C )
Date：2019-9-21