ForceDoor FS 1000 Installation Instructions And User Manual page 16

Increase time
Decrease time
4. AUTOMATIC CLOSING&TIME SETTING
NOTE: We recommend that Safety Photo Beams be used in any
installation where the Auto Close function is enabled.
a) Press and hold SET Button until " 1 " appears on the display, next
press the UP button until "4" appears on the display to enter this function
setting then release the button.
b) Press the SET button again, the unit is now in automatic close
adjustment mode. And then you will see a figure " 0 " with flash dot
appears on the display.
c) Press UP / Down button once to set the auto close time (0~9).
d) Press UP button to increase the time, or DOWN button to decrease
the time.
The close time is 15second*N, N=0~9. The maximum time is 135s. To
disable Auto Close Function, set time to zero (0).
e) Press SET button to confirm the set and it will back to standby
status automatically and display "ll".
NOTE: 1.The closing time is set on "0" as standard in factory.
2. If the Photo Cell Function is on, and it ' s broke by the
obstruction, the auto close time will stop for a while, and then continue the
automatic close time again.
12