Programming Instructions - ForceDoor FS 1000 Installation Instructions And User Manual

PROGRAMMING INSTRUCTIONS

Pre- Instruction for programme buttons
1.
Short click SET button : When it standby, it will clear the error, alarm display, and
return to normal display.
2.
Short click CODE button :
( In the Setting Status) Exit the current operation and return to the standby

interface.
When it standby, press the code, A dot will be indicated in the corner, now

entering the code leaning mode.
Now first click the button on the hand transmitter you want to use, the dot may
disappear ,then press again the same button on the hand transmitter, the dot will flash,
here, the code learning is finished.
3. Short press UP button : The door will open.
4. Short press DOWN button : The door will close.
(When the door is opening or closing, it will stop if you press any key.)
5. Long press SET button : Enter function setting interface.
6. Long press CODE button : Press and hold CODE button until a C is indicated on the
display. All stored remotes will be deleted.
7. Long press UP button : Increase the resilience. (Keep press DOWN button, after 4
seconds, it will scroll to display 0-1-2, choose the number you want. 1=increase 25%
2=increase 50%)
8. Long press DOWN button : Restore Factory Settings
Keep press DOWN button, after 4 seconds, it will scroll to display
garage door opener will restart.
Restart means all settings are back to factory settings, all learning things need to be done
again except the transmitter code learning.
9
, then the