Increase height
Decrease height
7. REVERSAL HEIGHT SETTING
a) Press and hold SET Button until " 1" appears on the display, next
press the UP button until "7" appears on the display to enter this function
setting then release the button.
b) Press the SET button again. The unit is now in reversal height
adjustment mode. And then you will see a figure "0" with flash dot appears
on the display.
c) Press UP / Down button once to set the reversal height while closing
(0~9).
d) Press UP button to increase , or DOWN button to decrease.
Figure " 0 " means the door will rebound to the open limit position.
Figure "1~9" means the door will rebound to the position of the whole
travel. One tenth to Nine tenth of the whole travel etc...
e) Press SET button to confirm the set and it will back to standby status
automatically and display "ll".
NOTE: The reversal height is set on "0" as standard in factory.
14