ForceDoor FS 1000 Installation Instructions And User Manual page 15

Decrease force
Increase speed
Decrease speed
2. OBSTRUCTION FORCE ADJUSTMENT
CAUTION: The obstruction force adjustment is set automatically
during programming. Normally no adjustment is necessary.
press the UP Button until "2" appears on the display to enter this function
setting then release the button.
mode. And then you will see a figure "3" with flash dot appears on the
Increase force
display.
button to decrease the force setting.
The minimum force is " 1 "
maximum force is "5".
status automatically and display "ll".
NOTE: The force is set on "3" as standard in factory.
3. TRAVEL SPEED SETTING
CAUTION: If you changed the speed again, it will cancel the
previous travel limit. The speed adjustment function will be
available only after you reset the travel limit.
press the UP button until "3" appears on the display to enter this function
setting then release the button.
mode. And then you will see a letter "A" with flash dot appears on the
display.
means the 80% of the travel speed. Figure "A" means the full speed.
status automatically and display "ll".
NOTE: The travel speed is set on full speed "A" as standard in factory.
a) Press and hold SET Button until "1"appears on the display, next
b) Press the SET button again, The unit is now in force adjustment
c) Press the UP button to increase the force setting or the DOWN
d) Press SET button to confirm the set and it will back to standby
a) Press and hold SET Button until "1"appears on the display, next
b) Press the SET button again. The unit is now in speed adjustment
c) Press the UP & DOWN button to choose the speed. Figure "8"
d) Press SET button to confirm the set and it will back to standby
11
and it can be adjusted upward. The