ForceDoor FS 1000 Installation Instructions And User Manual page 20

Buttons recognition function is closed
Buttons recognition function is open
Increase quantity
Decrease quantity
9. TRANSMITTER BUTTONS RECOGNITION FUNCTION SETTING
a) Press and hold SET button to enter this function setting until "9"
appears on the display then release the button.
b) Press the SET button again. The unit is now in buttons recognition
function adjustment mode. And then you will see a figure "1" with flash dot
appears on the display.
c) Press UP / Down button once to select if you want all the 4 buttons
can control the only one opener, or only the separate coded button can
control the opener.
Figure "0" means the buttons recognition function is closed. It means
if you coded 1 button with 1 opener, then all the 4 buttons on the
remote can control the opener. It's suit for the users who only have 1
automation door at home.
Figure "1 " means the buttons recognition function is open. If you
coded first button with first opener, then the first button will be the only
button on the remote can control the opener. It's suit for the users who
have more than 1 automation doors/gates at home.
d) Press SET button to confirm the set and it will back to standby status
automatically and display "ll".
NOTE: 1. The buttons recognition is set on "1" as standard in factory.
2. After you changed the buttons un-recognition into recognition,
please notice that only the coded button can control the opener.
A. CODES MEMORY QUANTITY SETTING
a) Press and hold SET Button until " 1 " appears on the display, next
press the UP button until "A" appears on the display to enter this function
setting then release the button.
b) Press the SET button again, the unit is now in remote quantity
adjustment mode. And then you will see a figure "A" again, but with flash dot
appears on the display.
c) Press UP / Down button once to set the remote quantity. (A or 1~9).
d) Figure "A " means the maximal quantity 50pcs. Press UP/DOWN
button once to increase or decrease quantity.
The remote quantity is set on 5pcs*N, N=1~9. (The quantity is the
multiple of 5)
e) Press SET button to confirm the set and it will back to standby status
automatically and display "ll".
NOTE: The remote quantity is set on "A" as standard in factory.
16