ForceDoor FS 1000 Installation Instructions And User Manual page 21

Increase height
Decrease height
b. REVERSAL HEIGHT IGNORANCE SETTING
a) Press and hold SET Button until "1" appears on the display, next
press the UP button until "b" appears on the display to enter this function
setting then release the button.
b) Press the SET button again. The unit is now in reversal height
ignorance adjustment mode. And then you will see a figure "1" with flash
dot appears on the display.
c) Press UP / Down button once to set the reversal height ignorance
while closing (0~9).
d) Press UP button to increase , or DOWN button to decrease.
Figure " 1~9 " means the door will still not rebound even though
there's obstacles in its closing path within 1cm~9cm away from the
close position. This function is most suitable for the Northern
Europe where will always snow on the ground.
e) Press SET button to confirm the set and it will back to standby
status automatically and display "ll".
NOTE: The reversal height is set on "1" as standard in factory.
C. PASS DOOR SWITCH TYPE SETTING
a) Press and hold SET Button until "1" appears on the display, next
press the UP button until "C" appears on the display to enter this function
setting then release the button.
b) Press the SET button again. The unit is now in the pass door switch
type adjustment mode. And then you will see a figure " 0" with flash dot
appears on the display.
c) Press UP / Down button once to set the pass door switch type. You
can choose "0" or "1" set.
Figure "0" means, the pass door function is normally open.
Figure "1" means, the pass door function is normally close.
e) Press SET button to confirm the set and it will back to standby
status automatically and display "ll".
NOTE: The pass door switch is set on "0" as standard in factory.
17