ForceDoor FS 1000 Installation Instructions And User Manual page 17

Increase
Decrease
Increase time
Decrease time
5. AUTOMATIC CLOSING CONDITION SETTING
a) Press and hold SET Button until "1" appears on the display, next
press the UP button until " 5 " appears on the display to enter this
function setting then release the button.
b) Press the SET button again. The unit is now in automatic close
condition adjustment mode. And then you will see a figure "1" with flash
dot appears on the display.
c) Press UP / Down button once to set the auto close condition. You
can choose "1" or "2" set.
Figure "1" means, the door only can auto close while in the open
limit position.
Figure "2" means, the door can auto close while the door is in any
position.
d) Press SET button to confirm the set and it will back to standby
status automatically and display "ll".
NOTE: 1. The closing condition is set on "1" as standard in factory.
2. The door will only automatic close while in its opening process,
but can't automatic close after it is stopped while in its closing process.
6. LED OFF DELAY TIME SETTING
a) Press and hold SET Button until "1" appears on the display, next
press the UP button until " 6 " appears on the display to enter this
function setting then release the button.
b) Press the SET button again. The unit is now in LED off delay time
adjustment mode. And then you will see a figure"3"with flash dot appears
on the display.
c) Press UP / Down button once to set the LED off delay time (1~9).
d) Press UP button to increase the time, or DOWN button to
decrease the time.
The delay time is 1 minute*N, N=1~9. The maximum delay time is 9
minutes.
e) Press SET button to confirm the set and it will back to standby
status automatically and display "ll".
NOTE: The LED off delay time is set on "3" as standard in factory.
13