Weber mt CR 5-II CCD Operating And Maintenance Manual page 9

Start-up procedure
During operation
Parking the machine
Fueling the machine
Do not disperse any sprays or other agents into the air intake
while the machine is starting up. They may lead to overheating
in the combustion chamber and result in damage to the
engine.
There is danger of suffocation if the operator starts up the
machine in closed rooms or in deep and tight trenches.
Operating the machine in closed rooms is prohibited. Provide
for an adequate supply of air before starting the machine.
One start procedure must not last longer than 30 seconds to
avoid damage to the engine. If the engine fails to turn over
after no more than 30 seconds, turn the ignition key back to
the "0" position and eliminate the cause.
If the ignition key fails to spring back to position "1" by itself,
the electric starter and the engine may sustain damage.
Abort the start procedure and shut down the machine.
Identify and rectify the cause before the next start attempt.
Monitor the surroundings to avoid injury to third parties or
material damage.
Suspend operation and shut down the machine if detecting
damage on the machine during operation.
Stop operation and shut down the machine if the light indica-
tors of the start module do not go out shortly after startup or
come on during operation.
The symbol is lit permanently during operation. It signals
that the engine is running. Refer to the section "Operation"
for the exact meaning of the individual light indicators.
Always park the machine on a level subsurface with sufficient
bearing capacity.
Parked machines presenting an obstacle must be secured in
accordance with statutory regulations, particularly in the area
of public traffic surfaces.
Engine and exhaust heat up during operation and can cause
burns on contact. Therefore, do not touch these components
during operation or shortly after the machine was switched off.
Spilled fuel may ignite and has a negative impact on the
environment. Therefore, wipe up spilled fuel and make sure
the gas cap is firmly tightened after fueling.
9