Weber mt CR 5-II CCD Operating And Maintenance Manual page 15

The start module (CR 5 E only)
1 Key switch
4 Charge level indicator (LED)
2 Oil pressure indicator (LED)
1
The key switch is used to switch the power supply (ignition)
to the machine on or off. It also actuates the electric starter
of the engine.
Switch in position "1"
The ignition is switched on.
Switch in position "0"
The ignition is switched off.
Switch in position "2"
The electric starter is actuated.
ATTENTION
Danger of material damage from running electric starter.
The ignition key must spring back from position "2" to
position "1". Otherwise:
Shut down the machine immediately.
This indicator comes on if the charging current supply to the
starter battery is insufficient. While operation of the machine
can resume, the cause of the insufficient charging current
supply must be identified and rectified.
This indicator warns of insufficient oil pressure.
Shut down the machine immediately when this indicator
comes on.
2
3
15