Samsung SPH-I500 Online User's Manual page 160

installed infrared driver. Check your computer's documentation to learn
if the computer supports infrared communication. If your desktop
computer uses Microsoft® Windows 98, 2000, or XP infrared
communication is built into the operating system.
To check the ports used for infrared communication:
In the Windows task bar, click
1.
Control Panel
Double-click
2.
Click the
3.
Select
4. Enable infrared communication
Note:
The COM port displayed in the drop-down box is the port where your
infrared device is attached. It should be different from any port used by the
HotSync Manager.
Make a note of which port is listed as "providing application
5.
support." You need this information to configure the HotSync
Manager for infrared communication.
Deselect any other check boxes in the
6.
Click
7. Apply
Configuring HotSync Manager for infrared communication
Next, you need to go to the HotSync Manager and specify the simulated
port used for infrared communication. To configure HotSync Manager
for infrared communication:
Click the HotSync Manager icon in the Windows system tray.
1.
Make sure
2.
Select
3. Setup
Click the
4.
In the Serial Port drop-down box, select the COM port that was given
5.
as the simulated port in the "Options" tab of the Infrared Monitor.
Click .
6. OK
Note:
The HotSync Manager is now communicating with the simulated
port defined for infrared communication. This means that you cannot use
.
.
Infrared
tab.
Options
and to exit.
OK
is checked on the menu.
Local
.
tab.
Local
, choose
Start
.
Options
Section 2: Understanding Your Phone
2Q: Advanced HotSync 157
, and then
Settings
tab.