Turning Your Phone On And Off - Samsung SPH-I500 Online User's Manual

Turning Your Phone ON and OFF

Turning Your Phone ON
Press for a few seconds. The phone will display "Powering On"
until it locates a signal, then it will automatically enter Standby mode
— the phone's idle state. At this point, you're ready to begin making and
receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a
Power Save feature is automatically activated. When a signal is found,
your phone automatically returns to Standby mode.
In Power Save mode, your phone searches for a signal periodically
without your intervention. You can also initiate a search for
PCS Service by pressing any key (when your phone is turned ON).
Tip:
The Power Save feature helps to conserve your battery power when
you are in an area where there is no signal.
Turning Your Phone OFF
Press for a few seconds until you see "Powering off..." on the
display screen.
Adjusting the Brightness
To adjust the brightness from the PDA menu, tap the brightness icon
1.
located in the upper right corner of the alpha Graffiti writing
area.
Use the slider to adjust the desired brightness level. Tap
2.
and exit.
Section 2: Understanding Your Phone
2A: Your PCS Phone - The Basics
to save
Done
23