Daikin RX-W Series Service Manual page 230

Field Settings for FDMQ, FFQ Series
Wireless Remote Factory set is 1. Change the wireless remote controller address setting by the following steps, if
Controller necessary.
1. Hold down
Address
2. Press
3. Press RESERVE button to confirm the setting.
4. Hold down
224
button and
field setting mode. (SETTING is indicated on the display).
Press FAN button and select display setting (A or b). Each time the button is pressed, the
display switches between A and b.
button and button to set the address.
Address can be set from 1 ~ 6, but set it to 1 ~ 3 and to same address as the transmitter board.
The transmitter board does not work with address 4 ~ 6.
/TEST button to quit the field setting mode and return to the normal display.
Field setting mode
Address
Multiple setting
/TEST button at the same time for at least 4 seconds to enter the
SiUS092230EA
(R14401)
Part 7 Trial Operation and Field Settings