Lan; Ipv4 - D-Link DIR-806A User Manual

DIR-806A AC750 Wi-Fi Router
User Manual

LAN

To configure the router's local interface, go to the Connections Setup / LAN page.

IPv4

Go to the IPv4 tab to change IPv4 address, configure the built-in DHCP server, or specify MAC
address and IPv4 address pairs.
Figure 78. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter
Mode of local IP
address assignment
IP address
Mask
Gateway IP address
Local IP Address
Available if the Access point, Repeater, or Client mode was
selected the Initial Configuration Wizard.
Select the needed value from the drop-down list.
Static: The IPv4 address, subnet mask, and the gateway IP
•
address are assigned manually.
Dynamic: The
•
parameters from the LAN DHCP server or from the router to
which it connects.
The IPv4 address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Available if the Access point, Repeater, or Client mode was
selected the Initial Configuration Wizard.
The gateway IPv4 address which is used by the router to connect to
the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
Page 93 of 197
Configuring via Web-based Interface
Description
router automatically obtains these