D-Link DIR-806A User Manual page 112

DIR-806A AC750 Wi-Fi Router
User Manual
If you want to disable activating the WPS function via the hardware button, on the tabs of both
bands, move the Enable WPS function with hardware button switch to the left and make
sure that the WPS function is not activated via the web-based interface.
To activate the WPS function via the web-based interface, on the tab of the relevant band, click the
ENABLE WPS button.
When the WPS function is enabled, the Information section is available on the page.
Parameter
WPS state
Default PIN code
Network name (SSID)
Network authentication The network authentication type specified for the wireless network.
Encryption
Password PSK
UPDATE
RESET TO
UNCONFIGURED
The state of the WPS function:
Configured (all needed settings are specified; these settings
•
will be used upon establishing the wireless connection)
Unconfigured (after activating the WPS function, the SSID
•
and the encryption key will be configured automatically, the
network authentication type will be changed to WPA2-PSK).
The PIN code of the router. This parameter is used when connecting
the router to a registrar to set the parameters of the WPS function.
The name of the router's wireless network.
The encryption type specified for the wireless network.
The encryption password specified for the wireless network.
Click the button to update the data on the page.
Click the button to reset the parameters of the WPS function.
Page 112 of 197
Configuring via Web-based Interface
Description