Firmware Update - D-Link DIR-806A User Manual

DIR-806A AC750 Wi-Fi Router
User Manual

Firmware Update

On the System / Firmware Update page, you can update the firmware of the router and
configure the automatic check for updates of the router's firmware.
!
Update the firmware only when the router is connected to your PC via a wired
connection.
The current version of the router's firmware is displayed in the Current firmware version field.
By default, the automatic check for the router's firmware updates is enabled. If the Access point,
Repeater, or Client mode was selected in the Initial Configuration Wizard and the Static value is
selected from the Mode of local IP address assignment list on the Connections Setup /
LAN page, the Gateway IP address field should also be filled in on order to realize automatic
check.
If a firmware update is available, a notification will be displayed in the top right corner of the page.
To disable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the left and click the APPLY SETTINGS button.
To enable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the right and click the APPLY SETTINGS button.
By default, in the Remote server URL field, the D-Link update server address
(fwupdate.dlink.ru) is specified.
You can update the firmware of the router locally (from the hard drive of your PC) or remotely
(from the update server).
Figure 136. The System / Firmware Update page.
Page 175 of 197
Configuring via Web-based Interface