Removal Of Electrical Parts - Denso MovinCool CLIMATE PRO K63 Service Manual

Removal of Electrical Parts

1. Control box
a) Remove the service panel from the logo side panel. (See step 3 on page 23)
b) Remove the following number of screws and remove each electrical part from the control box.
- Relay for Compressor: two (2) screws
- Terminal block 1: two (2) screws
- Terminal block 2: two (2) screws
- Capacitor for Condenser motor (2): one (1) screw for each capacitor
- Reverse Phase Relay: two (2) screws
c) Remove the relay for condenser fan motor from the holder as shown.
Relay Board
Screw (2)
Relay for Compressor
Relay for Condenser Fan Motor
Holder
Capacitor for Condenser Fan Motor (2)
50
Screw (2)
Reverse Phase Relay
Screw (2)
Screw (2)
Terminal Block 2
(For Input/ Output Signal)
Screw (2)
Terminal Block 1
(For Power)