Denso MovinCool CLIMATE PRO K63 Service Manual page 31

Removal of Louver
4. Remove the five (5) M6 x L12 screws as shown from the logo side panel.
5. a) Loosen the two (2) screws located in the lower side of the upper front panel.
• To loosen the two (2) screws to remove the upper front panel, you must carefully flex
open both condenser and logo side panels as shown.
Upper Front Panel
Logo Side Panel
b) Remove the four (4) M4 x L10 screws located on the top of the upper front panel.
c) Carefully lift upper front panel straight up to remove from the unit.
CAUTION
Screw (4)
M4 x L10
Loosen Screw (2)
31
Screw (5)
M6 x L12
Logo Side Panel
Condenser Side Panel