NordicTrack PERFORMANCE 1450 User Manual page 10

8. Set the console assembly face down on a soft
surface to avoid scratching the console
assembly.
Remove all the Screws (A) attaching the
Crossbar (93). Next, lift off the Crossbar.
Discard the Screws.
9. IMPORTANT: To avoid damaging the
Crossbar (93), do not use power tools and
do not overtighten the #10 x 3/4" Screws (9)
or the #10 x 3/4" Flat Head Screws (112).
Orient the Crossbar (93) as shown. Attach the
Crossbar to the Handrails (87, 88) with two #10
x 3/4" Flat Head Screws (112), two #10 x 3/4"
Screws (9), and two 1/4" Star Washers (35) as
shown. Start all four Screws, and then tighten
each of them.
10. With the help of a second person, hold the con-
sole assembly near the Left Handrail (88).
Connect the Upright Wire (81) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
8
93
9
112
9
35
10
Console
Wire
81
10
Console
Assembly
A
112
9
35
93
88
Console
Assembly
Console
Wire
81
Wire
Tie
87
88