Wireless Resource Control - D-Link NUCLIAS CONNECT DAP-2610 Manual

D-Link DAP-2610 User Manual
The Wireless Resource Control window is used to configure the wireless connection settings so that the device can detect the better wireless
connection in your environment.
Airtime Fairness: Click the drop-down menu to enable or disable the
airtime fairness function.
Band Steering: Use the drop-down menu to Enable the 5G Pre-
ferred function. When the wireless clients support
both 2.4 GHz and 5 GHz and the 2.4 GHz signal is
not strong enough, the device will use 5 GHz as the
higher priority.
Wireless band: Select 2.4GHz or 5GHz.
Connection Limit: Select Enable or Disable. This is an option for load
balancing. This determines whether to limit the num-
ber of users accessing this device. The exact number
is entered in the User Limit field below. This feature
allows the user to share the wireless network traffic
and the client using multiple APs. If this function is
enabled and when the number of users exceeds this
value, or the network utilization of this AP exceeds
the percentage that has been specified, the DAP-2610 will not allow clients to associate with the AP.
User Limit: Set the maximum amount of users that are allowed access (zero to 64 users) to the device using the specified wireless
band. The default setting is 20.
Use the drop-down menu to Enable the 11n Preferred function. The wireless clients with 802.11n protocol will have
11n Preferred:
higher priority to connect to the device.
Network Utilization: Set the maximum utilization of this access point for service. The DAP-2610 will not allow any new clients to associate
with the AP if the utilization exceeds the value the user specifies. Select a utilization percentage between 100%, 80%,
60%, 40%, 20%, and 0%. When this network utilization threshold is reached, the device will pause for one minute to al-
low network congestion to dissipate.

Wireless Resource Control

28