Table of Contents
Advertisement
Available languages
Available languages
• the isolating switch is easily accessible by the customer
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.
Adjusting the bracket position
Fix the hob on the work surface by screw 4 brackets on the bottom case of hob
(see picture) after installation.
A
B
C
Screw
Bracket
Screw hole
Cautions
1. The induction hotplate must be installed by qualified personnel or technicians.
We have professionals at your service. Please never conduct the operation by
yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the hob
electronics
3.The induction hotplate shall be installed such that better heat radiation can be
ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.
D
Bottom case
EN-27
Connecting the hob to the mains power supply
This
hob
must
be
connected
to
the
Before connecting the hob to the mains power supply, check
1.
the domestic wiring system is suitable for the power drawn by the
2.
the voltage corresponds to the
3.
the power supply cable sections can withstand the load specified on the rating plate.
To
connect
the
hob
to
the
mains
power
devices, as they can cause overheating and
The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring system is suitable without
alterations. Any alterations
must only be made by a qualified
The power supply should be connected in compliance with the relevant standard,
or a single
-
pole circuit breaker. The method of connection is shown below.
• If the cable is damaged or to be replaced, the operation must be carried out the
by after-sale agent with dedicated tools to avoid any accidents.
•
If the appliance is being connected directly to the mains an omnipolar
circuit
-
breaker must be installed with a minimum opening of 3mm between
contacts.
•
The
installer must ensure that the correct electrical connection has been made
and that it is compliant with safety
•
The cable must not be bent or
compressed.
•
The cable must be checked regularly and replaced by authorised
only.
mains
power
supply
only
by
a
suitably
qualified
that:
hob.
value given in the rating
plate
supply,
do
not
use
adapters,
reducers,
fire.
electrician.
regulations.
technicians
EN
-
28
person.
or
branching
Advertisement
Table of Contents
