Steps
1. Align the pin 1 indicator of the heat-sink to the system board and then place the processor and heat-sink module on the
processor socket.
NOTE:
To avoid damaging the fins on the heat-sink, do not press down on the heat-sink fins.
NOTE:
Ensure that the processor and heat-sink is held parallel to the system board to prevent damaging the
components.
2. In the sequential order (1->2->3->4), tighten the captive screws to secure the processor and heat-sink module to the
system board.
NOTE:
Tighten the screws in a sequential order (1,2,3,4) as printed on the system board.
Next steps
1. Install the
air
shroud.
2. Install the
system
cover.
3. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
system
cover.
3. Remove the
air
shroud.
NOTE:
Removing the coin-cell battery resets the BIOS setup program settings to default. It is recommended that you note
the BIOS setup program settings before removing the coin-cell battery.
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the removal procedure.
36
Removing and installing components
After working inside your
Before working inside your
computer.
computer.