Steps
1. Align and place the front PERC module at an angle into its slot on the computer.
2. Tighten the two thumb screws to secure the front PERC to the computer chassis.
3. Connect the cable to its connector on the front PERC module.
Next steps
1. Install the
backplane
cover.
2. Install the
system
cover.
3. Follow the procedure in
Hard drive backplane
Removing the hard drive backplane
Prerequisites
1. Follow the procedure in
2. Remove the
system
cover.
3. Remove the
backplane
4. Remove the
front PERC
About this task
The following images indicate the location of the hard drive backplane and provide a visual representation of the removal
procedure.
44
Removing and installing components
After working inside your
Before working inside your
cover.
module.
computer.
computer.