Cooper WaveLinx Lite User And Programming Manual page 162

5: To update a single device, tap the device's 'Update' button. (For Battery Powered Wallstations only, when prompted to confirm that the
'battery wallstation is awake', press any button on the wallstation and then tap 'confirm' to proceed.)
To update multiple devices within range, tap the desired device rows to highlight them and then select the 'Update' button at the bottom of
the page. Stay in range of the device(s) until the progress indicates that the updates are complete. (Battery Powered Wallstations will not
allow selection of multiple devices.)
6: Verify the update was successful. Rescan the devices and review for 'Current' firmware versions.
Refresh device
scan
7: Move within Bluetooth range (within 60 feet) of additional devices and repeat these steps until all devices are updated.
97 If the battery level falls below 2.5V, the wallstation will prompt for a battery replacement if the user attempts a firmware update and will not allow the firmware update to
proceed.
162
www.cooperlighting.com
Tap 'Update'
to update
single device
Tap 'Update'
Verify firmware is
'Current'
Tap to select
more than one
device
Update
compete
User Manual: WaveLinx Lite (4.0)
97