Cooper WaveLinx Lite User And Programming Manual page 144

Device Details Occupancy Sensor Page
144
www.cooperlighting.com
Setting Default
Current Status N/A
Hold Time 20 Minutes
Sensitivity Dependent on
sensor type
Sensor Enabled
Occupancy N/A
Setting
Blink to Identify N/A
Test Mode N/A
LED Indication Enabled
Description
Displays the status of the sensor, either occupied or
unoccupied.
Note: Status reflected does not include the hold time delay. It reflects if
actual motion activity was occurring at the time the status last loaded.
Displays the sensor's programmed hold time.
Slide the switch to low sensitivity if a sensor is detecting
motion outside of the desired coverage area. Switch to High to
regain the full motion sensing range.
Slide the switch to disable the occupancy sensor for this
device. This can be helpful if a sensor is false-triggering due to
challenging placement. Examples: near air vents or doorways.
Note: It is recommended to avoid placing sensors within 3ft (1m) of air
vents.
Tap on the right arrow icon '
occupancy settings configuration.
Tap on the icon ' ' to cause the connected fixture to flash on
and off for a 15 second period. To cancel 'blink to identify'
before the timer expires, tap '
If test mode is activated (slide switch to activate), the sensor
will be placed in test mode for 10 minutes. During test mode,
the occupancy sensor will operate with a 10 second hold time.
Disabling the LED is not recommended as it is often used to
determine if the sensor is operational. If the sensor LED flash
is a major distraction, slide the switch to disabled.
User Manual: WaveLinx Lite (4.0)
' to navigate directly to the
' again.