Life Fitness Weekly Service Manual page 68

3. Insert deck through the striding belt and place on the LifeSprings carefully.
WARNING: Do not damage stride sensor when installing deck.
4. Secure the deck with deck screws.
a. Line up holes in deck with Tinnerman clip holes.
b. Push down on deck and install screw. Torque to 27-33 in-lbs (31-38 kg-cm).
NOTE: Apply light pressure on screw to avoid bending the Tinnerman clip.
5. Tighten rear roller adjusting screws to slightly tension striding belt.
Striding Belt Tracking and Tensioning
1. Center striding belt about the front and rear rollers at approximately ½ inch (1.3 cm) from rear roller edge. Also
position the belt edges within the belt barrier.
Length
38 ¾" (98.4 cm)
38 ¾" (98.4 cm)
38 15/16" (98.9 cm)
Page 66 of 143
Description
Loose length
Tensioned length for new
striding belt
Tensioned length for used
striding belt