Introduction; Safety Regulations And "Ce" Marking; General Instructions; Description - S&P CTB ECOWATT PLUS Manual

1. INTRODUCTION

Thank you for purchasing this appliance. It has been manufactured in full compliance with applicable safety regulations and
EN EU standards. Please read this instruction book carefully, as it contains important information for your safety during the insta-
llation, use and maintenance if this product.
Keep it at hand for future reference.
Please check that the appliance is in perfect condition when you unpack it, as all factory defects are covered by the S&P gua-
rantee.

2. SAFETY REGULATIONS AND "CE" MARKING

S&P technicians are fi rmly committed to research and development of ever more effi cient products and in compliance with
current safety regulations.
The instructions and recommendations given below refl ect current regulations, principally regarding safety, and therefore
are based on compliance with general regulations. Therefore, we recommend all people exposed to hazards to strictly follow
the safety regulations in force in your country. S&P will not be held liable for any possible harm or damage caused by non-
compliance with the safety regulations, as well as caused by modifying the product.
The CE mark and the corresponding declaration of conformity are proof of the product's conformity with current EU regula-
tions.

3. GENERAL INSTRUCTIONS

A hazard analysis of the product has been carried out as provided in the Machine Directive. The manual contains information
for all personnel exposed to these hazards, with aim of preventing possible harm or damage due to faulty handling or main-
tenance.
All maintenance operations (ordinary and extraordinary) must be carried out with the machine switched off and the electrical
power supply disconnected.
Before connecting the power supply cable to the terminal strip, make sure the mains voltage corresponds to the voltage indi-
cated on the specifi cations plate of the unit.

4. DESCRIPTION

4.1. LOCATIONS

IMPORTANT
At the bottom of the control box, two tubes (marked as "V" and "P") come from the inside part of the fan. As the fan is
supplied as constant pressure mode (COP), tube "P" is connected and "V" disconnected and blocked with a plastic stopper.
To keep this confi guration unless chapter 6.6.3. is previously ridden.
34