Table of Contents
Advertisement
11. Swivel the seat approximately 45° to one side.
See Figure 4-31.
Figure 4-31
12. Attach the swivel pin bracket with the flat side
towards the footrest support using the two
hex bolts and washers. Ensure that one of the
swivel pins is engaged into the slot in the
swivel cam. See Figure 4-32.
Figure 4-32
13. Connect the seat cable to the 8-pin connector
on the chassis. See Figure 4-33.
Figure 4-33
14. If the lift is equipped with the optional key
lock, ensure that the key switch on the
armrest control is in the locked position; the
key should be in the vertical position.
See Figure 4-34.
PINNACLE HD STAIR LIFT: SECTION 4
Figure 4-34
15. Turn the red "On/Off" switch located on
the top of the chassis to the "On" position.
You should hear a single beep and the LED
indicator light on the armrest control should
cycle through a test sequence, showing red,
yellow and green respectively. If any of the
system controls or safety sensors are engaged
the LED indicator light will turn to yellow.
16. If the LED indicator light is not green, check
the safety sensors. If the LED indicator light is
still not green after testing the sensors, turn
the unit off and re-check all wire plugs. Turn
the unit on and re-check the LED indicator
light cycle. When the LED indicator light
remains green, the lift is ready to operate.
See Figure 4-35.
Seat swivel sensor
Footrest lower sensor
Upper foot pan safety
sensor
Front foot pan safety
sensor
Uphill safety sensor
Downhill safety sensor
Figure 4-35
SL600HD PINNACLE STAIR LIFT:
INSTALLATION
Seat should be in the
locked position
Check by pushing in on
the safety pan on the
footrest
Check by pushing on
the safety pan on the
footrest
Check by pushing on
the safety pan on the
footrest
Ensure nothing is
blocking upward
passage
Ensure nothing is
blocking downward
passage
Install Manual
15
25MAR2022 | 75403 E
Advertisement
Table of Contents
