Aa. Growing Seat Pan; Bb Check Out - Sunrise Medical Zippie TS Manual

Hide thumbs Also See for Zippie TS:

Table of Contents

Z IPPI E T S

Z I PPI E T S

AA. GROWING SEAT PAN (optional)

1. Removing and Attaching the Seat Pan

a. To remove, grasp front of seat pan and firmly pull upward until seat mounting clips (A) disengage from

the frame.

b. To reattach, position seat pan on frame rail as desired and push down firmly on seat pan where it is

attached to the seat mounting clips. Be sure to engage all four clips on frame rails.

NOTE– Rear of seat pan will be labeled.

Check for engagement by pulling up lightly on seat pan. It should not move upward. Failure to check for

engagement may lead to injury if the seat mounting clips are not fully seated.

2. Adjusting Seat Pan Width

a. Remove the hardware (B) that secures each seat mounting clip (A) to the seat pan.

b. Position the seat mounting clips to the desired position, reattach the screws. Each hole is .5-in apart

for a total of 2-in of width adjustment range.

NOTE– Torque screws to 11.3 Nm [100 in-lbs].

c. Repeat steps "a" and "b" for each mounting clip.

NOTE– Both sides must be mounted to the same hole position.

3. Adjusting Seat Pan Depth

a. Loosen the two lock nuts (C) on underside of seat pan that attach the front seat pan panel to rear

seat pan panel.

b. Reposition seat pan to the desired length, and reattach the lock nuts.

NOTE– Torque lock nuts to 11.3 Nm [100 in-lbs].

BB. CHECK-OUT

After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also

perform smoothly. If you have any problems, follow these procedures:

1. Review the set-up and check-out sections to ensure the chair was properly prepared.

2. Review troubleshooting guide.

3. If your problem persists, contact Sunrise Medical customer service. See the introduction page for details

on how to contact Sunrise Medical customer service.

MK-100208 RevB

WARNING

IX. DEALER SERVICE AND ADJUSTMENT

Front

Rear

Table of Contents