Z-Finity Footrest System; Articulating Legrest; Elevating Legrest - Sunrise Medical Zippie TS Manual

Z IPPI E T S
M. Z-FINITY FOOTREST SYSTEM
™
The footrest position is key to keeping the body in the proper alignment and providing a stable support for
your legs and torso. Ensure that your Sunrise Medical authorized dealer has correctly adjusted your footrests
and/or legrests with the advice of a health care provider. The original setup should not be changed without
first checking with that health care provider. Legrests and footrests should be swung out of the way, or
removed, for transfers.
NOTE – Footplate must have at least 2 inches of clearance between the footplate and the ground to pre-
vent hitting obstacles and risking a fall or tip-over.
1. Footrest/Footplate positioning using the rotational clamp
a. Loosen the two rotational/angle clamp screws (A).
b. Rotate the footrest/footplate until the desired position and angle is achieved.
c. Tighten the clamp hardware to proper torque (DO NOT EXCEED a 13.6 Nm [120 in-lb] maximum
torque).
2. Footrest positioning using footplate spacers
a. Remove footplate spacers (B).
b. Slide footplate to desired depth position.
c. Replace footplate spacers.
3. Height range adjustment (Direct Mount Footrest)
a. Adjust the footplate mounting position by removing the button head screw from the adjustment hole
and moving the assembly to the desired position.
b. Tighten hardware to proper torque 13.6 Nm [120 in-lb] maximum.
4. Height range adjustment (Extension Mount Footrest)
a. Loosen set screw (D).
b. Slide footrest extension tube up or down inside frame tube to desired height.
c. Tighten set screw to proper torque 13.6 Nm [120 in-lb] maximum.
N. ARTICULATING LEGREST
1. Height Adjustment of the Calf Pad
a. Loosen the retaining nut (E) located at the back of the calf pad bracket assembly.
b. Slide the calf pad bracket assembly up or down.
c. Tighten the retaining nut (E) once the pad is in the desired position.
2. Height Adjustment with Extension Tube
a. (See "Swing-away Height Adjustment" Section)
O. ELEVATING LEGREST
1. Height Adjustment of the Calf Pad
a. Loosen the retaining nut (F) located at the back of the calf pad bracket assembly.
b. Slide the calf pad bracket assembly up or down.
c. Tighten the retaining nut (F) once the pad is in the desired position.
2. Height Adjustment with Extension Tube
a. (See "Swing-away Height Adjustment" Section)
40 41 42
44
45
IX. DEALER SERVICE AND ADJUSTMENT
24
A
E
MK-100208 RevB
40
41
42
44
45