Clevo W355SSQ Service Manual page 37

Processor Installation Procedure
1. Insert the CPU (Figure 9a), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
A
IT!), and turn the release latch
2. Insert the heat sink at an angle of around 30° as indicated in
C
3. Tighten the CPU heat sink screws in the order
and Figure 9d).
4. Replace the component bay cover.
a.
A
b.
B
towards the lock symbol (Figure
B
, , , ,
1 2 3 4 5
c.
C
d.
6
4 3
8
1
2
7
9b).
Figure 9c.
, & (the order as indicated on the label
6 7
45°
8
5
Note:
Tighten the screws in the order
as indicated on the label.
Removing and Installing the Processor 2 - 13
Disassembly
Figure 9
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Insert the heat sink.
d. Tighten the screws.

A. CPU
C. Heat Sink
• 7 Screws