Clevo W355SSQ Service Manual page 41

Memory (under Keyboard) Upgrade Process
5. Turn off the computer, turn it over and remove the battery
keyboard (page 2 - 14).
6. The memory socket will be visible at point
7. Gently pull the two release latches (
8. The RAM module will pop-up, and you can remove it.
4
d.
e.
4
6
9. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
10. The module's pin alignment will allow it to only fit one way. Make sure the module is seated as far into the slot as it
will go. DO NOT FORCE the module; it should fit without much pressure.
11. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
12. Replace the bay cover and screws.
13. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
(page 2 - 5), component bay cover
(Figure 13d).
5
) on the sides of the memory socket in the direction indicated below.
6 & 7
f.
5
7
Be careful not to touch the metal pins on the module's connect-
ing edge. Even the cleanest hands have oils which can attract
particles, and degrade the module's performance.
(page 2 -
4

Contact Warning
Removing the System Memory (RAM) 2 - 17
Disassembly
Figure 13
RAM Module
10) and
(under keyboard)
Removal
d. The secondary RAM
module will be visible
at point 5 .
e. Pull the release lat-
ches.
f. Remove the module.

4 RAM Module