Table of Contents
Advertisement
Quick Links
Installation/Operator Manual
WARNING:
For your safety the
information in this manual must be
followed to minimize the risk of fire or
explosion and to prevent property
damage, personal injury or death.
— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your
building.
• Clear the room, building or area of all
occupants.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
— Installation and service must be
performed by a qualified installer, service
agency or the gas supplier.
ES20
AVERTISSEMENT: Assurez-vous de bien
suivre les instructions données dans cette
notice pour réduire au minimum le risque
d'incendie ou d'explosion ou pour éviter
tout dommage matériel, toute blessure ou
la mort.
— Ne pas entreposer ni utiliser d'essence
ni d'autres vapeurs ou liquides
inflammables à proximité de cet
appareil ou de tout autre appareil.
— QUE FAIRE SI VOUS SENTEZ UNE
ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareils.
• Ne touchez à aucun interrupteur. Ne
pas vous servir des téléphones se
trouvant dans le bâtiment.
• Évacuez la pièce, le bâtiment ou la
zone.
• Appelez immédiatement votre
fournisseur de gaz depuis un voisin.
Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le
fournisseur de gaz, appelez le service
des incendies.
— L'installation et l'entretien doivent être
assurés par un installateur ou un service
d'entretien qualifié ou par le fournisseur
de gaz.
American Dryer Corporation
Fall River MA 02720-4781 USA
Telephone: +1 (508) 678-9000 / Fax: +1 (508) 678-9447
e-mail: techsupport@amdry.com
88 Currant Road
www.adclaundry.com
ADC Part No. 112176-5
Advertisement
Table of Contents
Related Manuals for American Dryer Corp. ES20
Summary of Contents for American Dryer Corp. ES20
- Page 1 ES20 Installation/Operator Manual AVERTISSEMENT: Assurez-vous de bien WARNING: For your safety the suivre les instructions données dans cette information in this manual must be notice pour réduire au minimum le risque followed to minimize the risk of fire or d’incendie ou d’explosion ou pour éviter explosion and to prevent property tout dommage matériel, toute blessure ou...
- Page 2 The illustrations included in this manual may not depict your particular dryer exactly. IMPORTANT For your convenience, log the following information: ES20 DATE OF PURCHASE _________________________________________________________ MODEL NO. ______________ RESELLER’S NAME ___________________________________________________________________________________ SERIAL NUMBER(S) ___________________________________________________________________________________...
-
Page 3: Table Of Contents
WARNING WARNING Children should not be allowed to play on or near the dryer(s). Children should be supervised if Proposition 65 near dryer(s) in operation. Use of this product could expose you to substances Under no circumstances should the dryer door from fuel combustion that contain chemicals switch(es), lint door/drawer switch(es), or heat known to the State of California to cause cancer,... -
Page 4: Safety Precautions
Safety Precautions ___________________ WARNING WARNING Do not use heat for drying articles that contain plastic, foam, sponge rubber, or similarly textured rubber For your safety, the information in this manual must materials. Drying in a heated tumbler may damage be followed to minimize the risk of fire or explosion plastics or rubber and also may be a fire hazard. - Page 5 The operation of this appliance may affect the operation of other types of gas appliances, which take their air for safe combustion from the same room. If in doubt, consult the NOTES _____________________________________________________ appliance manufacturer(s). Use this dryer only for its intended purpose, drying fabrics. ____________________________________________________________ The “Cool Down”...
-
Page 6: Specifications
Specifications _____________________________________________________________________ 9.07 kg MAXIMUM CAPACITY (DRY WEIGHT) 20 lb 65.41 cm TUMBLER DIAMETER 25-3/4” TUMBLER DEPTH 24” 60.96 cm 212.38 L TUMBLER VOLUME 7-1/2 cu ft TUMBLER/DRIVE MOTOR 1/4 hp 0.19 kW 0.37 kW BLOWER/FAN MOTOR 1/2 hp DOOR OPENING (DIAMETER) 19-3/8”... - Page 7 Specifications _____________________________________________________________________ 112176 - 5 www.adclaundry.com...
-
Page 8: Installation Procedures
Installation Procedures ______________ Unpacking / Setting Up _______________ Installation should be performed by competent professional Remove protective shipping material (i.e., plastic wrap and in accordance with local, state, and country codes. In the optional shipping box) from the dryer. absence of these codes, the installation must conform to applicable American National Standards: ANSI Z223.1- IMPORTANT: Dryer must be transported and handled in LATEST EDITION (National Fuel Gas Code) or ANSI/NFPA... -
Page 9: Fresh Air Supply Requirements
Domestic Type I A = 10-inches (25.4 cm) A = 6-inches (15.24 cm) B = 8-inches (20.32 cm) B = 10-inches (25.40 cm) EXAMPLE: For a bank of four dryers, two unrestricted openings measuring 10-inches by 8-inches (25.4 cm by 20.32 cm) are acceptable. - Page 10 Vertical Venting IMPORTANT: It is recommended that exhaust or booster fans not be used in the exhaust ductwork system. When vertical dryer venting is used, the length of the ductwork Exhaust back pressure measured by a manometer/ from the dryer to the outside exhaust outlet, must not exceed magnehelic in the exhaust duct must be no less than 0 12 feet (3.66 meters).
-
Page 11: Electrical Information
IMPORTANT: No more than four dryers should be Each dryer should be connected to an independently connected to one main common duct. protected branch circuit. The dryer must be connected with copper wire only. Do not use aluminum wire, which could The illustration below shows the minimum cross-sectional cause a fire hazard. - Page 12 Electrical Service Specifications Grounding Gas and Steam Models Only A ground (earth) connection must be provided and installed in accordance with local, state, and national regulations or ELECTRICAL SERVICE SPECIFICATIONS codes of the country of origin. In the absence of these codes, grounding must conform to applicable requirements of the IMPORTANT: 208 VAC AND 230/240 VAC ARE NOT THE SAME.
-
Page 13: Gas Information
Gas Models Only Electric Models Only 120-240V Application with Neutral Single-Phase (1ø) Wiring Connections / Hookup 200-240V Application without Neutral CAUTION: The dryer must be grounded. A ground lug has been provided for this purpose. Input connection wiring must be sized properly to handle the dryer’s current draw. - Page 14 IMPORTANT: Failure to comply with these codes or ordinances, and/or the requirements stipulated in this manual, can result in personal injury and improper NOTES _____________________________________________________ operation of the dryer. For ease of service, the individual gas supply line of each ____________________________________________________________ dryer must have its own manual shutoff valve.
- Page 15 Heat Input / Gas Consumption / Orifice (Injector) Data (For Non-CE [European] and Non-AGA [Australia] Models Only) Gas Specifications for Non-CE and Non-AGA Approved Dryers** Nominal Supply Gross Burner Orifice Orifice Size Heating Value Pressure Heat Input Pressure (Injector) Type Quantity B tu /ft in WC...
-
Page 16: Converting From One Family Of Gas To Another
Piping / Connections WARNING Inlet connection is 3/8” M.N.P.T. Never test for leaks with a flame!!! CE and Australian dryer connections will be B.S.P.T., all others will be N.P.T. There should be a minimum 6-inch (15.24 cm) clearance between the back guard and the first bend in the gas piping Converting from One Family for ease of servicing. - Page 17 Regulated Gas Valve IMPORTANT: Use extreme care when removing and replacing orifice (injector). This orifice (injector) is made Refer to “Gas Pressure Adjustment” on page 18 to adjust of brass, which is easily damaged. the gas valve to the appropriate burner pressure listed on page 15.
-
Page 18: Water Information
Gas Pressure Test Procedure With dryer operating, check the manifold (burner) pressure at the tap on the gas valve to ensure proper operating Turn gas cock in gas supply line to “OFF” position. pressure (refer to chart on page 15). 50 Hz dryers: Back out miniature screw inside pressure tap Gas Pressure Adjustment and attach manometer (refer to the illustration on page 17). -
Page 19: Preparation For Operation / Start-Up
Preparation for Operation / Start-Up _ Water Connections The water connection is made to the 3/4”-11.5 NH hose The following items should be checked before attempting adaptor, which is shipped in the tumbler and must be to operate the dryer: installed to the 1/2”... -
Page 20: Preoperational Instructions
Electrical Dryers NOTE: The dryer can be paused or stopped at any time. Press the “X” key (Pause/Stop) once to pause the cycle. Check to ensure that electric oven/contactor assembly is Press the “ ” key to restart the cycle, or press the “X” key activating. -
Page 21: Warranty Information
Warranty Information _________________ All returns must be properly packaged to ensure that they are not damaged in transit. Damage claims are the Returning Warranty Cards responsibility of the shipper. Before any dryer leaves the factory test area, a warranty card IMPORTANT: No replacements, credits, or refunds will be is placed on the inside of the main door glass. - Page 22 IMPORTANT: The frequency of cleaning the lint screen can best be determined from experience at each location. NOTES ______________________________________________________ Weekly Clean lint accumulation from lint chamber, thermostat, and ____________________________________________________________ microprocessor temperature sensor area. ____________________________________________________________ WARNING ____________________________________________________________ To avoid the hazard of electrical shock, discontinue electrical supply to the dryer.
-
Page 23: Data Label Information
Data Label Information ____________________________________________________________ Standard Label CE Label AGA Label When contacting ADC, the information on the data label is required to ensure proper service/parts assistance. The data label is located at the upper left rear of the dryer behind the back guard. -
Page 24: Programming
Programming _________________________ Event Codes Defined: Top Pocket / Bottom E1 / E4: While attempting to turn on the burner, no burner return Enter Service Mode by Inserting Key and Turning Clockwise signal was received within RADIANT SENSOR COOL DOWN TIME. Main Service Mode window will appear and offer 5 selections: 1: Machine Info 2: Program Setup... - Page 25 NOTES __________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ 112176 - 5 www.adclaundry.com...
- Page 26 ADC Part No. 112176 5 - 06/15/15...