Table of Contents
Advertisement
CONFIGURING AND COMMUNICATING WITH YOUR DEVICE
AT#SGACT=1,0
The device responds with OK.
Transferring FTP File to FTP Server
To connect to FTP server and upload files:
1.
Check signal strength.
Enter:
AT+CSQ
2.
Verify device is registered on the cellular network.
Enter:
AT+CEREG?
Should return:
+CEREG: 0,1 or +CEREG: 0,5
OK
3.
Activate context
Enter:
Verizon:
AT#SGACT=3,1
Other Networks:
AT#SGACT=1,1
4.
Set FTP operations timeout to 10 seconds
Enter:
AT#FTPTO=100
5.
Configure FTP server IP address with username and password.
Enter:
AT#FTPOPEN="###.##.###.#","username","password",0
where ###.##.###.# is the IP address and the username and password for the FTP server.
6.
Configure file transfer type.
Enter:
AT#FTPTYPE=#
where # is 0 for binary or 1 for ASCII.
7.
Enter the file name to be sent to the FTP server and initiate connection.
Enter:
AT#FTPPUT="file.txt"
The device responds with:
CONNECT
8.
Send the file through the device.
Closing the FTP Data Connection
After the file is sent:
1.
Enter the escape sequence.
Enter:
28
®
MultiConnect
Cell MTC-LNA4 User Guide
Advertisement
Table of Contents
