Check Point QUANTUM SANDBLAST TE2000XN-28VM Getting Started Manual page 9

Information to user:
The user's manual or instruction manual for an intentional or unintentional radiator shall caution the user that
changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. In cases where the manual is provided only in a form other than
paper, such as on a computer disk or over the Internet, the information required by this section may be
included in the manual in that alternative form, provided the user can reasonably be expected to have the
capability to access information in that form.
CE (European Union (EU) Electromagnetic Compatibility Directive)
This device is herewith confirmed to comply with the requirements set out in the Council Directive on the
Approximation of the Laws of the Member States relating to Electromagnetic Compatibility Directive
(2014/30/EU).
The above product conforms with Low Voltage Directive 2014/35/EU and complies with the requirements
relating to electrical equipment designed for use within certain voltage limits.
BS (UKCA)
This device is herewith confirmed to comply with the listed regulation requirements:
Electrical Equipment (Safety) Regulations 2016 – SI 2016 No. 1101
Electromagnetic Compatibility Regulations 2016 – SI 2016 No. 1091
Federal Communications Commission (FCC) statement for a Class A digital device or peripheral
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and receiver.
n
Connect the equipment to an outlet on a circuit that is different from the one to which the receiver is
n
connected.
Consult the dealer or an experienced radio/TV technician for help.
n
ICES (Canadian Department Compliance Statement)
This Class A digital apparatus complies with Canadian ICES-003.
VCCI Compliance Statement
This section provides the compliance statement for the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI), which governs radio frequency emissions in Japan.
Safety, Environmental, and Electronic Emissions Notices
Sandblast TE2000XN-28VM/56VM Appliances Getting Started Guide | 9