Operations; General - Shop fox W1872 Owner's Manual

Model W1872 (For Machines Mfd. Since 04/19)

General

This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
The overview below provides the novice machine operator
with a basic understanding of how the machine is used
during operation, so the machine controls/components
discussed later in this manual are easier to understand.
Due to its generic nature, this overview is NOT intended
to be an instructional guide.
To.complete.a.typical.operation,.the.operator.does.the.
following:
1. Examines workpiece to make sure it is suitable for
cutting.
2. If necessary, adjusts table tilt to correct angle of
desired cut.
3. Loosens hold-down shoe height knob, adjusts blade
guard height to just clear workpiece (no more than
⁄ "), then retightens hold-down shoe height knob.
1
4
4. Verifies workpiece can safely pass all the way
through blade without interference from other
objects.
5. Puts on safety glasses and a respirator.
6. Starts dust collector and turns machine ON.
7. Sets saw blade speed.
8. Holds workpiece firmly and flat against table and
then pushes workpiece into blade at a steady and
controlled rate until cut is complete.
9. Rotates variable-speed dial to slowest speed, then
turns machine OFF.

OPERATIONS

-19-
To. reduce. your. risk. of. serious. injury.
or. damage. to. the. machine,. read. this.
entire.manual.BEFORE.using.machine.
To. reduce. the. risk. of. eye. injury. and.
long-term. respiratory. damage,. always.
wear. safety. glasses. and. a. respirator.
while.operating.this.machine.
If you are an inexperienced operator,
we strongly recommend that you read
books or trade articles, or seek training
from an experienced operator of this
type of machinery before performing
unfamiliar operations. Above.all,.safety.
must.come.first!